Drug mi se uselio u glanc novu gajbu na Brdu. Sve mu je u fulu, i ima i roletne na
dugmići. Ali su roletne malo glupave, dugmići su pored prozora i mora da se drže
dok ne dođu do željene pozicije. A to traje 30-40 sekundova, što je njemu mnogo.
Pa se raskukao da mu uturim daljince. Stigoše daljinci i prijemi za 12 $ komplet
po roletni. I danas sam se malo sa tim zanimao, ali moraće da malo radi dorada
zida. To sam njemu prepusio :) . Malo je zeznuto što bi bilo u paraleli i dugmići i
daljinci, pa bi mogo da bidne kvar ako bi se dale istovremeno suprotne komande.
Noralno da sam potražio na netu neko uputstvo za ove skalamocije i unutri piše:
Important!
XXXX motors must never be wired in parallel.
Damage caused by parallel wiring will not be covered under warranty.
Problem
When the switch is turned to either the up or the down position, both motors will turn
together.
One of the motors (A) will stop at its pre-set limit before the other (B).
Current from motor (B) will then flow back through to motor (A) through capacitor
C2 and micro-switches M3 and M1.
There will be constant feedback from one motor to the other causing the motors to
continuously change direction, but with very little travel.
The motors will eventually burn out..
A moj problem se vidi ovde:
Use one switch per motor. Do not wire one motor to several switches without
using the appropriate Somfy electronic control!
This will damage the contacts in the micro-switch.
http://norfolkblinds.com.au/do...eralMotorisationNotesSomfy.pdf
Blago onome ko rano poludi, ceo zivot mu u veselju prodje
Sinhronizovan rad motornih zavjesa/skrinova
Re: Sinhronizovan rad motornih zavjesa/skrinova
, a sâme motore paralelno vezao.
