[es] - Koje zice u LAN kablu se ne koriste?

Take 5

Član broj: 200551
Poruke: 1423
77.46.178.*

+12 Profil

Re: Koje zice u LAN kablu se ne koriste?

^{14.02.2009. u 07:46 - pre 184 meseci}

Ethernet Cable - Color Coding Diagram

T-568A Straight-Through Ethernet Cable

T-568B Straight-Through Ethernet Cable

RJ-45 Crossover Ethernet Cable

Basic Theory:

Citat:

The TIA/EIA 568-A standard which was ratified in 1995, was replaced by the TIA/EIA 568-B standard in 2002 and has been updated since. Both standards define the T-568A and T-568B pin-outs for using Unshielded Twisted Pair cable and RJ-45 connectors for Ethernet connectivity. The standards and pin-out specification appear to be related and interchangeable, but are not the same and should not be used interchangeably.

Both the T-568A and the T-568B standard Straight-Through cables are used most often as patch cords for your Ethernet connections. If you require a cable to connect two Ethernet devices directly together without a hub or when you connect two hubs together, you will need to use a Crossover cable instead.

A good way of remembering how to wire a Crossover Ethernet cable is to wire one end using the T-568A standard and the other end using the T-568B standard. Another way of remembering the color coding is to simply switch the Green set of wires in place with the Orange set of wires. Specifically, switch the solid Green (G) with the solid Orange, and switch the green/white with the orange/white.

Ethernet Cable Tips:

* A straight-thru cable has identical ends.
* A crossover cable has different ends.
* A straight-thru is used as a patch cord in Ethernet connections.
* A crossover is used to connect two Ethernet devices without a hub or for connecting two hubs.
* A crossover has one end with the Orange set of wires switched with the Green set.
* Odd numbered pins are always striped, even numbered pins are always solid colored.
* Looking at the RJ-45 with the clip facing away from you, Brown is always on the right, and pin 1 is on the left.
* No more than 1/2" of the Ethernet cable should be untwisted otherwise it will be susceptible to crosstalk.
* Do not deform, do not bend, do not stretch, do not staple, do not run parallel with power cables, and do not run Ethernet cables near noise inducing components.

By looking at a T-568A UTP Ethernet straight-thru cable and an Ethernet crossover cable with a T-568B end, we see that the TX (transmitter) pins are connected to the corresponding RX (receiver) pins, plus to plus and minus to minus. You can also see that both the blue and brown wire pairs on pins 4, 5, 7, and 8 are not used in either standard. What you may not realize is that, these same pins 4, 5, 7, and 8 are not used or required in 100BASE-TX as well. So why bother using these wires, well for one thing its simply easier to make a connection with all the wires grouped together. Otherwise you'll be spending time trying to fit those tiny little wires into each of the corresponding holes in the RJ-45 connector.

"Take Five" is the famous jazz piece written by Paul Desmond and performed by The Dave Brubeck Quartet. It is famous for its distinctive saxophone line and use of the unusual quintuple (5/4) time, from which its name is derived.

Take Five (1966)

Take Five by Al Jarreau 1976

Odgovor na temu